Search  
Browse by Category
Glossary Contact Us
Knowledge Base
 Anti-Spyware
 Broadband Modems
 Cable Modems
 DSL Modems
 2Wire 2700HG
 2Wire 2701
 Accton DSL 1000
 Actiontec 1520/1524
 Actiontec GT701
 Actiontec GT701-WG
 Older Firmware Instructions
 Actiontec M1000
 Arescom NetDSL 800
 Cisco 605
 Cisco 675/678
 Intel PRO/DSL 2100/2200
 Intel PRO/DSL 3200
 Broadband Routers
 E-mail Clients
 FAQ's
 Firewalls
 FTP Clients
 Networking
 Operating Systems
 Security
 Virus Protection
 Web Browsers
 Web Publishing
Knowledge Base > Broadband Modems > DSL Modems > Actiontec GT701-WG > USB: View Network Settings in Windows 2000
USB: View Network Settings in Windows 2000
  1. Click on the Start button, go to Settings, then to Network and Dial-up Connections.

  2. Right click on Local Area Connection and left click on Properties.

  3. Select Internet Protocol (TCP/IP) and click Properties.

  4. If the ISP requires a dynamic IP address, select the options shown below or select Use the following IP address and type in their static IP and DNS server IP's. Click OK when you are done.

  5. Click OK on this screen and it will take you back out to the Network and Dial-up Connections screen.



.: Powered by Lore 1.7.0